• 3/16” thick face channel
• 1” slotted on center for maximum flexibility
• Use for Wall and Island Sections
• Steel welded construction
• Includes side flanges to retain Back material, leveling leg for uneven floors
• Includes Top Caps on Uprites 36”-66”H

• Features 2” conduit hole for greater electrical access
• Includes leveling legs for uneven flooring
• Install straight-in using integral spring latch
• Actual Bracket length is 3″ less than nominal Deck depth

*Note: All 28″ deep and 31″ deep Base Brackets are rated for Heavy Duty capacity, and can be used for both Standard Duty and Heavy Duty applications.

SYSTEM CAPACITIES ARE LIMITED BY THE UPRITE. FOR HEAVY DUTY CAPACITY, HEAVY DUTY BASE BRACKETS MUST BE USED WITH HEAVY DUTY UPRITES.

• Standard Deck style for Island and Wall runs
• Molding accommodates a 1.235” tag
• 1/4” perforations for clip-on accessories
• Evenly distributed load of 600 lbs (13″-19″D) and 800 lbs (22″-31″D)

• 3’ and 4’ Fronts have an electrical knockout
• Snaps in place beneath Deck to cover gap between Deck and floor
• Fits flush with floor regardless of leveling adjustments

• Use Open Base Front instead of Closed Base Front
• Order CHR Base Brackets when using Open Base Front

• All Island and Wall Sections require one Top, Center and Bottom Rail
• 2’ and 30” sections use two Top Rails to make a Splicer Rail
• Electrical knockouts included on all Rails

• All Island and Wall Sections require one Top, Center and Bottom Rail
• 96”H-144”H Backs require two Center Rails
• Center Rail finish is always N/A because it’s hidden
• Electrical knockouts included on all Rails

• All Island and Wall Sections require one Top, Center and Bottom Rail
• Electrical knockouts included on all Rails
• Also used for 2′ and 30″ Slotwall Backs

• All Island and Wall Sections require one Top, Center and Bottom Rail
• 78”H – 144”H Backs require one Splicer Rail
• Splicer rail is not available in 2’ or 30”
• Use two top rails for splicer rail on 2′ and 30″ wide sections.
• Electrical knockouts included on all Rails

• Use one-piece Backs for heights 36”-72”
• For heights above 72” order 2 backs, see table below
• Pegboard 9/32” diameter holes, 1” on center
• To order the correct size Back, take Uprite height minus 6

• Attaches to the first and last Base Bracket in a run
• Comes in a pair
• One pair is required to finish a Wall run
• Two pairs are required to finish an Island run

• One-piece trim (Two-pieces if 102”-144”H) snaps onto first and last Uprite or Extension Uprite in a run
• Can be used on both sides of Extension Uprites where Extension Backs are not used

• Anchors freestanding 2′, 30″, 3′, or 4’W Wall End Display to 3′ or 4′ Island Sections
• Accommodates up to 9″ offset (3″ increments)
• Required when a Wall End Display or Contoured End Display has an unacceptable freestanding
  height-to-depth ratio (Levelers exceed 6:1)
• Wall End and Gondola End Section Top Rail not required
• Stabilizes top of WEDNB (No Base End Cap)

COMPONENTS (ORDERED SEPARATELY):

• Wall End Display End Top Rail (WEDER)
• Wall End Display Gondola Top Rail (WEDGR)